linux-imx
Public
Source
committed c0fae22f486x
tristate "CS5535/CS5536 Geode Multi-Function General Purpose Timer (MFGPT) support"## Misc strange devices#menu "Misc devices"config SENSORS_LIS3LV02D tristate depends on INPUT select INPUT_POLLDEV default nconfig AD525X_DPOT tristate "Analog Devices Digital Potentiometers" depends on (I2C || SPI) && SYSFS help If you say yes here, you get support for the Analog Devices AD5258, AD5259, AD5251, AD5252, AD5253, AD5254, AD5255 AD5160, AD5161, AD5162, AD5165, AD5200, AD5201, AD5203, AD5204, AD5206, AD5207, AD5231, AD5232, AD5233, AD5235, AD5260, AD5262, AD5263, AD5290, AD5291, AD5292, AD5293, AD7376, AD8400, AD8402, AD8403, ADN2850, AD5241, AD5242, AD5243, AD5245, AD5246, AD5247, AD5248, AD5280, AD5282, ADN2860, AD5273, AD5171, AD5170, AD5172, AD5173, AD5270, AD5271, AD5272, AD5274 digital potentiometer chips. See Documentation/misc-devices/ad525x_dpot.txt for the userspace interface. This driver can also be built as a module. If so, the module will be called ad525x_dpot.config AD525X_DPOT_I2C tristate "support I2C bus connection" depends on AD525X_DPOT && I2C help Say Y here if you have a digital potentiometers hooked to an I2C bus. To compile this driver as a module, choose M here: the module will be called ad525x_dpot-i2c.config AD525X_DPOT_SPI tristate "support SPI bus connection" depends on AD525X_DPOT && SPI_MASTER help Say Y here if you have a digital potentiometers hooked to an SPI bus. If unsure, say N (but it's safe to say "Y"). To compile this driver as a module, choose M here: the module will be called ad525x_dpot-spi.config ATMEL_TCLIB bool "Atmel AT32/AT91 Timer/Counter Library" depends on ARCH_AT91 help Select this if you want a library to allocate the Timer/Counter blocks found on many Atmel processors. This facilitates using these blocks by different drivers despite processor differences.config ATMEL_TCB_CLKSRC bool "TC Block Clocksource" depends on ATMEL_TCLIB default y help Select this to get a high precision clocksource based on a TC block with a 5+ MHz base clock rate. Two timer channels are combined to make a single 32-bit timer. When GENERIC_CLOCKEVENTS is defined, the third timer channel may be used as a clock event device supporting oneshot mode (delays of up to two seconds) based on the 32 KiHz clock.config ATMEL_TCB_CLKSRC_BLOCK int depends on ATMEL_TCB_CLKSRC default 0 range 0 1 help Some chips provide more than one TC block, so you have the choice of which one to use for the clock framework. The other TC can be used for other purposes, such as PWM generation and interval timing.config DUMMY_IRQ tristate "Dummy IRQ handler" default n ---help--- This module accepts a single 'irq' parameter, which it should register for. The sole purpose of this module is to help with debugging of systems on which spurious IRQs would happen on disabled IRQ vector.