linux-imx

md/r5cache: caching phase of r5cache

As described in previous patch, write back cache operates in two
phases: caching and writing-out. The caching phase works as:
1. write data to journal
   (r5c_handle_stripe_dirtying, r5c_cache_data)
2. call bio_endio
   (r5c_handle_data_cached, r5c_return_dev_pending_writes).

Then the writing-out phase is as:
1. Mark the stripe as write-out (r5c_make_stripe_write_out)
2. Calcualte parity (reconstruct or RMW)
3. Write parity (and maybe some other data) to journal device
4. Write data and parity to RAID disks

This patch implements caching phase. The cache is integrated with
stripe cache of raid456. It leverages code of r5l_log to write
data to journal device.

Writing-out phase of the cache is implemented in the next patch.

With r5cache, write operation does not wait for parity calculation
and write out, so the write latency is lower (1 write to journal
device vs. read and then write to raid disks). Also, r5cache will
reduce RAID overhead (multipile IO due to read-modify-write of
parity) and provide more opportunities of full stripe writes.

This patch adds 2 flags to stripe_head.state:
 - STRIPE_R5C_PARTIAL_STRIPE,
 - STRIPE_R5C_FULL_STRIPE,

Instead of inactive_list, stripes with cached data are tracked in
r5conf->r5c_full_stripe_list and r5conf->r5c_partial_stripe_list.
STRIPE_R5C_FULL_STRIPE and STRIPE_R5C_PARTIAL_STRIPE are flags for
stripes in these lists. Note: stripes in r5c_full/partial_stripe_list
are not considered as "active".

For RMW, the code allocates an extra page for each data block
being updated.  This is stored in r5dev->orig_page and the old data
is read into it.  Then the prexor calculation subtracts ->orig_page
from the parity block, and the reconstruct calculation adds the
->page data back into the parity block.

r5cache naturally excludes SkipCopy. When the array has write back
cache, async_copy_data() will not skip copy.

There are some known limitations of the cache implementation:

1. Write cache only covers full page writes (R5_OVERWRITE). Writes
   of smaller granularity are write through.
2. Only one log io (sh->log_io) for each stripe at anytime. Later
   writes for the same stripe have to wait. This can be improved by
   moving log_io to r5dev.
3. With writeback cache, read path must enter state machine, which
   is a significant bottleneck for some workloads.
4. There is no per stripe checkpoint (with r5l_payload_flush) in
   the log, so recovery code has to replay more than necessary data
   (sometimes all the log from last_checkpoint). This reduces
   availability of the array.

This patch includes a fix proposed by ZhengYuan Liu
<liuzhengyuan@kylinos.cn>

Signed-off-by: Song Liu <songliubraving@fb.com>
Signed-off-by: Shaohua Li <shli@fb.com>