Commits
Tony Lindgren committed 3d009c8c61f
gpio: omap: Fix bad device access with setup_irq() Similar to omap_gpio_irq_type() let's make sure that the GPIO is usable as an interrupt if the platform init code did not call gpio_request(). Otherwise we can get invalid device access after setup_irq(): WARNING: CPU: 0 PID: 1 at drivers/bus/omap_l3_noc.c:147 l3_interrupt_handler+0x214/0x340() 44000000.ocp:L3 Custom Error: MASTER MPU TARGET L4CFG (Idle): Data Access in Supervisor mode during Functional access ... [<c05f21e4>] (__irq_svc) from [<c05f1974>] (_raw_spin_unlock_irqrestore+0x34/0x44) [<c05f1974>] (_raw_spin_unlock_irqrestore) from [<c00914a8>] (__setup_irq+0x244/0x530) [<c00914a8>] (__setup_irq) from [<c00917d4>] (setup_irq+0x40/0x8c) [<c00917d4>] (setup_irq) from [<c0039c8c>] (omap_system_dma_probe+0x1d4/0x2b4) [<c0039c8c>] (omap_system_dma_probe) from [<c03b2200>] (platform_drv_probe+0x44/0xa4) ... We can fix this the same way omap_gpio_irq_type() is handling it. Note that the long term solution is to change the gpio-omap driver to handle the banks as separate driver instances. This will allow us to rely on just runtime PM for tracking the bank specific state. Reported-by: Russell King <rmk+kernel@arm.linux.org.uk> Cc: Javier Martinez Canillas <javier@dowhile0.org> Cc: Kevin Hilman <khilman@kernel.org> Cc: Santosh Shilimkar <ssantosh@kernel.org> Tested-by: Felipe Balbi <balbi@ti.com> Signed-off-by: Tony Lindgren <tony@atomide.com> Signed-off-by: Linus Walleij <linus.walleij@linaro.org>