Commits
Merge tag 'renesas-dt2-for-v4.14' of https://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas into next/dt Pull "Second Round of Renesas ARM Based SoC DT Updates for v4.14" from Simon Horman: * Use newly added Gen-3 fallback compat string This is consistent with ongoing efforts to use per-generation fallback strings where appropriate across devices found on R-Car SoCs. The aim of the effort being to strike a balance between the limited information available about the compatibility of devices found on different SoCs and the desire to ease enabling devices on new SoCs. This has no run-time effect due to the presence of a per-SoC compat string. * Enable second CPU core on RZ/G1M (r8a7743) The RZ/G1M has two CA15 cores running at up to 1.5GHz * Enable frequency scaling on RZ/G1M (r8a7743) * Add six I2C cores to RZ/G1M (r8a7743) SoC DT This is a step towards enabling these cores on boards that use this SoC * Add CEC clock for HDMI transmitter to R-Car M2-W (r8a7791) Koelsch Hans Verkuil says "The adv7511 on the Koelsch board has a 12 MHz fixed clock for the CEC block. Specify this in the dts to enable CEC support." * Add PFC support to RZ/G1E (r8a7745) SoC and add Ethernet and SCIF2 pins to SK-RZG1E board. This allows the kernel to control multiplexed pins for Ethernet and SCIF2 rather than relying on setup inherited at boot. * tag 'renesas-dt2-for-v4.14' of https://git.kernel.org/pub/scm/linux/kernel/git/horms/renesas: ARM: dts: r8a7791: Use R-Car SATA Gen2 fallback compat string ARM: dts: r8a7790: Use R-Car SATA Gen2 fallback compat string ARM: dts: r8a7743: Add OPP table for frequency scaling ARM: dts: r8a7743: Add APMU node and second CPU core ARM: dts: koelsch: Add CEC clock for HDMI transmitter ARM: dts: sk-rzg1e: add Ether pins ARM: dts: sk-rzg1e: add SCIF2 pins ARM: dts: r8a7745: add PFC support ARM: dts: r8a7743: Add I2C DT support
