Merge tag 'arm-soc/for-4.11/devicetree' of http://github.com/Broadcom/stblinux into next/dt
This pull request contains Broadcom ARM-based SoC Device Tree changes for 4.11,
please pull the following changes:
- Rafal enables the UART by default on all BCM5301x, BCM4708, BCM4709 since
every device found out there has it enabled by default. He also fixes the
LED definitions for the Luxul XWR-3100 device, enables USB controllers and
their respective PHY devices, specifies the correct GPIO to power on USB
HUBs, adds the additional RAM bank for somes devices, and finally sets the
correct 5Ghz frequency limits on the Netgear R8000
- Jon does a number of Norsthar Plus SoC cleanups, fixes NAND partitions unit
addresses, adds QSPI support to a bunch of boards, adds Ethernet switch ports
to the BCM958625K reference board, enables 3rd Ethernet MAC instance to
relevant DTSes, enables Ethernet on the XMC board, and finally adds SD/MMC
support to the XMC board
- Boris adds the Video Encoder nodes to the Raspberry Pi DTS include files
ands enables it on the relevant boards
- Dan adds support for two new Luxul devices: XAP-1410 and XWR-1200, both
BCM47081 based SoCs
* tag 'arm-soc/for-4.11/devicetree' of http://github.com/Broadcom/stblinux:
ARM: dts: bcm283x: Enable the VEC IP on all RaspberryPi boards
ARM: dts: bcm283x: Add VEC node in bcm283x.dtsi
ARM: dts: BCM5301X: Add DT for Luxul XWR-1200
ARM: dts: BCM5301X: Add DT for Luxul XAP-1410
ARM: dts: BCM5301X: Set 5 GHz wireless frequency limits on Netgear R8000
ARM: dts: NSP: Add SD/MMC support
ARM: dts: NSP: Add Ethernet to NSP XMC
ARM: dts: NSP: Add and enable amac2
ARM: dts: NSP: Add BCM958625K switch ports
ARM: dts: NSP: Add QSPI support to missing boards
ARM: dts: NSP: Correct NAND partition unit address
ARM: dts: NSP: DT Clean-ups
ARM: dts: BCM53573: Specify USB ports of on-SoC controllers
ARM: dts: BCM5301X: Specify all RAM by including an extra block
ARM: dts: BCM5301X: Set GPIO enabling USB power on Netgear R7000
ARM: dts: BCM5301X: Specify USB controllers in DT
ARM: dts: BCM5301X: Fix LAN LED labels for Luxul XWR-3100
ARM: dts: BCM5301X: Enable UART by default for BCM4708(1), BCM4709(4) & BCM53012
Signed-off-by: Olof Johansson <olof@lixom.net>
