Merge tag 'ux500-dt-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-stericsson into next/fixes-non-critical
From Linus Walleij <linus.walleij@linaro.org>:
Ux500 Device Tree fixes
All are necessary to make a proper DT boot on the v3.9
series:
- IRQ edges.
- Register defines.
- FSMC clock.
- Ethernet clk fixup (one patch to drivers/net ACKed by
David Miller)
- Proper IOS and regulator voltages for MMCI.
- AB8500 GPIOs restored after they were fixed in the v3.9
merge window from the pinctrl tree.
- There is also a minor cleanup in the platform code, but it
is strongly connected to the other patches.
* tag 'ux500-dt-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/linusw/linux-stericsson:
ARM: ux500: allow Snowball access to the AB8500 GPIO pins
ARM: ux500: enable AB8500 GPIO for HREF
ARM: ux500: Remove traces of the ios_handler from platform code
ARM: ux500: Use the GPIO regulator framework for SDI0's 'en' and 'vsel'
ARM: ux500: Setup correct settling time for the MMCI regulator
ARM: ux500: Use the correct name when supplying a GPIO enable pin
ARM: ux500: Specify which IOS regulator to use for MMCI
ARM: ux500: Specify the ux5x0 MMCI regulator's on/off GPIO as high-enable
ARM: ux500: Set correct MMCI regulator voltages in the ux5x0 Device Tree
mmc: mmci: Move ios_handler functionality into the driver
net/smsc911x: Provide common clock functionality
clk: ux500: Provide an alias for the SMSC911x Ethernet chip
clk: ux500: Ensure the FMSC clock is obtainable
ARM: ux500: Provide a means to obtain the SMSC9115 clock when DT is enabled
ARM: ux500: Include the PRCMU's Secure Registers in DB8500's DT
ARM: ux500: Change IRQ from low-to-high edge triggered to high-to-low
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
