Commits
Alexey Brodkin committed 8f02d8da969
stmmac: check IRQ availability early on probe Currently we're getting IRQs after lots of resources are already allocated: * netdev * clocks * MDIO bus Also HW gets initialized by the time when checking IRQs as well. Now there's a possibility for master interrupt controller to be not probed yet. This will lead to exit from GMAC probe routine with "- EPROBE_DEFER" and so deferred probe will hapen later on. But since we exited the first GMAC probe without release of all allocated resources there could be conflicts on subsequent probes. For example this is what happens for me: --->8--- stmmaceth e0018000.ethernet: no reset control found stmmac - user ID: 0x10, Synopsys ID: 0x37 Ring mode enabled DMA HW capability register supported Normal descriptors RX Checksum Offload Engine supported (type 2) TX Checksum insertion supported Enable RX Mitigation via HW Watchdog Timer libphy: stmmac: probed eth0: PHY ID 20005c7a at 1 IRQ POLL (stmmac-0:01) active platform e0018000.ethernet: Driver stmmaceth requests probe deferral ... ... ... stmmaceth e0018000.ethernet: no reset control found stmmac - user ID: 0x10, Synopsys ID: 0x37 Ring mode enabled DMA HW capability register supported Normal descriptors RX Checksum Offload Engine supported (type 2) TX Checksum insertion supported Enable RX Mitigation via HW Watchdog Timer ------------[ cut here ]------------ WARNING: CPU: 0 PID: 6 at fs/sysfs/dir.c:31 sysfs_warn_dup+0x4e/0x68() sysfs: cannot create duplicate filename '/devices/platform/axs10x_mb/e0018000.ethernet/mdio_bus/stmmac-0' CPU: 0 PID: 6 Comm: kworker/u2:0 Not tainted 4.0.0-rc1-next-20150303+#8 Workqueue: deferwq deferred_probe_work_func Stack Trace: arc_unwind_core+0xb8/0x114 warn_slowpath_common+0x5a/0x8c warn_slowpath_fmt+0x2e/0x38 sysfs_warn_dup+0x4e/0x68 sysfs_create_dir_ns+0x98/0xa0 kobject_add_internal+0x8c/0x2e8 kobject_add+0x4a/0x8c device_add+0xc6/0x448 mdiobus_register+0x6c/0x164 stmmac_mdio_register+0x112/0x264 stmmac_dvr_probe+0x6c0/0x85c stmmac_pltfr_probe+0x2e4/0x50c platform_drv_probe+0x26/0x5c really_probe+0x76/0x1dc bus_for_each_drv+0x42/0x7c device_attach+0x64/0x6c bus_probe_device+0x74/0xa4 deferred_probe_work_func+0x50/0x84 process_one_work+0xf8/0x2cc worker_thread+0x110/0x478 kthread+0x8a/0x9c ret_from_fork+0x14/0x18 ---[ end trace a2dfaa7d630c8be1 ]--- ------------[ cut here ]------------ WARNING: CPU: 0 PID: 6 at lib/kobject.c:240 kobject_add_internal+0x218/0x2e8() kobject_add_internal failed for stmmac-0 with -EEXIST, don't try to register things with the same name in the same di. CPU: 0 PID: 6 Comm: kworker/u2:0 Tainted: G W 4.0.0-rc1-next-20150303+ #8 Workqueue: deferwq deferred_probe_work_func Stack Trace: arc_unwind_core+0xb8/0x114 warn_slowpath_common+0x5a/0x8c warn_slowpath_fmt+0x2e/0x38 kobject_add_internal+0x218/0x2e8 kobject_add+0x4a/0x8c device_add+0xc6/0x448 mdiobus_register+0x6c/0x164 stmmac_mdio_register+0x112/0x264 stmmac_dvr_probe+0x6c0/0x85c stmmac_pltfr_probe+0x2e4/0x50c platform_drv_probe+0x26/0x5c really_probe+0x76/0x1dc bus_for_each_drv+0x42/0x7c device_attach+0x64/0x6c bus_probe_device+0x74/0xa4 deferred_probe_work_func+0x50/0x84 process_one_work+0xf8/0x2cc worker_thread+0x110/0x478 kthread+0x8a/0x9c ret_from_fork+0x14/0x18 ---[ end trace a2dfaa7d630c8be2 ]--- libphy: mii_bus stmmac-0 failed to register : Cannot register as MDIO bus stmmac_pltfr_probe: main driver probe failed stmmaceth: probe of e0018000.ethernet failed with error -22 --->8--- Essential fix is to check for IRQs availability as early as possible and then safely go to deferred probe if IRQs are not there yet. Signed-off-by: Alexey Brodkin <abrodkin@synopsys.com> Cc: Vineet Gupta <vgupta@synopsys.com> Cc: Andy Shevchenko <andriy.shevchenko@linux.intel.com> Cc: Giuseppe Cavallaro <peppe.cavallaro@st.com> Cc: Sonic Zhang <sonic.zhang@analog.com> Cc: David S. Miller <davem@davemloft.net> Signed-off-by: David S. Miller <davem@davemloft.net>