linux-imx

block, bfq: consider also past I/O in soft real-time detection

BFQ privileges the I/O of soft real-time applications, such as video
players, to guarantee to these application a high bandwidth and a low
latency. In this respect, it is not easy to correctly detect when an
application is soft real-time. A particularly nasty false positive is
that of an I/O-bound application that occasionally happens to meet all
requirements to be deemed as soft real-time. After being detected as
soft real-time, such an application monopolizes the device. Fortunately,
BFQ will realize soon that the application is actually not soft
real-time and suspend every privilege. Yet, the application may happen
again to be wrongly detected as soft real-time, and so on.

As highlighted by our tests, this problem causes BFQ to occasionally
fail to guarantee a high responsiveness, in the presence of heavy
background I/O workloads. The reason is that the background workload
happens to be detected as soft real-time, more or less frequently,
during the execution of the interactive task under test. To give an
idea, because of this problem, Libreoffice Writer occasionally takes 8
seconds, instead of 3, to start up, if there are sequential reads and
writes in the background, on a Kingston SSDNow V300.

This commit addresses this issue by leveraging the following facts.

The reason why some applications are detected as soft real-time despite
all BFQ checks to avoid false positives, is simply that, during high
CPU or storage-device load, I/O-bound applications may happen to do
I/O slowly enough to meet all soft real-time requirements, and pass
all BFQ extra checks. Yet, this happens only for limited time periods:
slow-speed time intervals are usually interspersed between other time
intervals during which these applications do I/O at a very high speed.
To exploit these facts, this commit introduces a little change, in the
detection of soft real-time behavior, to systematically consider also
the recent past: the higher the speed was in the recent past, the
later next I/O should arrive for the application to be considered as
soft real-time. At the beginning of a slow-speed interval, the minimum
arrival time allowed for the next I/O usually happens to still be so
high, to fall *after* the end of the slow-speed period itself. As a
consequence, the application does not risk to be deemed as soft
real-time during the slow-speed interval. Then, during the next
high-speed interval, the application cannot, evidently, be deemed as
soft real-time (exactly because of its speed), and so on.

This extra filtering proved to be rather effective: in the above test,
the frequency of false positives became so low that the start-up time
was 3 seconds in all iterations (apart from occasional outliers,
caused by page-cache-management issues, which are out of the scope of
this commit, and cannot be solved by an I/O scheduler).

Tested-by: Lee Tibbert <lee.tibbert@gmail.com>
Signed-off-by: Paolo Valente <paolo.valente@linaro.org>
Signed-off-by: Angelo Ruocco <angeloruocco90@gmail.com>
Signed-off-by: Jens Axboe <axboe@kernel.dk>