linux-imx

powerpc/powernv/ioda2: Update iommu table base on ownership change

On POWERNV platform, in order to do DMA via IOMMU (i.e. 32bit DMA in
our case), a device needs an iommu_table pointer set via
set_iommu_table_base().

The codeflow is:
- pnv_pci_ioda2_setup_dma_pe()
	- pnv_pci_ioda2_setup_default_config()
	- pnv_ioda_setup_bus_dma() [1]

pnv_pci_ioda2_setup_dma_pe() creates IOMMU groups,
pnv_pci_ioda2_setup_default_config() does default DMA setup,
pnv_ioda_setup_bus_dma() takes a bus PE (on IODA2, all physical function
PEs as bus PEs except NPU), walks through all underlying buses and
devices, adds all devices to an IOMMU group and sets iommu_table.

On IODA2, when VFIO is used, it takes ownership over a PE which means it
removes all tables and creates new ones (with a possibility of sharing
them among PEs). So when the ownership is returned from VFIO to
the kernel, the iommu_table pointer written to a device at [1] is
stale and needs an update.

This adds an "add_to_group" parameter to pnv_ioda_setup_bus_dma()
(in fact re-adds as it used to be there a while ago for different
reasons) to tell the helper if a device needs to be added to
an IOMMU group with an iommu_table update or just the latter.

This calls pnv_ioda_setup_bus_dma(..., false) from
pnv_ioda2_release_ownership() so when the ownership is restored,
32bit DMA can work again for a device. This does the same thing
on obtaining ownership as the iommu_table point is stale at this point
anyway and it is safer to have NULL there.

We did not hit this earlier as all tested devices in recent years were
only using 64bit DMA; the rare exception for this is MPT3 SAS adapter
which uses both 32bit and 64bit DMA access and it has not been tested
with VFIO much.

Signed-off-by: Alexey Kardashevskiy <aik@ozlabs.ru>
Acked-by: Gavin Shan <gwshan@linux.vnet.ibm.com>
Reviewed-by: David Gibson <david@gibson.dropbear.id.au>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>