linux-imx

genirq: Set initial affinity in irq_set_affinity_hint()

Problem:
The default behavior of the kernel is somewhat undesirable as all
requested interrupts end up on CPU0 after registration.  A user can
run irqbalance daemon, or can manually configure smp_affinity via the
proc filesystem, but the default affinity of the interrupts for all
devices is always CPU zero, this can cause performance problems or
very heavy cpu use of only one core if not noticed and fixed by the
user.

Solution:
Enable the setting of the initial affinity directly when the driver
sets a hint.

This enabling means that kernel drivers can include an initial
affinity setting for the interrupt, instead of all interrupts starting
out life on CPU0. Of course if irqbalance is still running then the
interrupts will get moved as before.

This function is currently called by drivers in block, crypto,
infiniband, ethernet and scsi trees, but only a handful, so these will
be the devices affected by this change.

Tested on i40e, and default interrupts were spread across the CPUs
according to the hint.

drivers/block/mtip32xx/mtip32xx.c:3
drivers/block/nvme-core.c:2
drivers/crypto/qat/qat_dh895xcc/adf_isr.c:3
drivers/infiniband/hw/qib/qib_iba7322.c:2
drivers/net/ethernet/intel/i40e/i40e_main.c:3
drivers/net/ethernet/intel/i40evf/i40evf_main.c:3
drivers/net/ethernet/intel/ixgbe/ixgbe_main.c:3
drivers/net/ethernet/mellanox/mlx4/en_cq.c:2
drivers/scsi/hpsa.c:3
drivers/scsi/lpfc/lpfc_init.c:3
drivers/scsi/megaraid/megaraid_sas_base.c:8
drivers/soc/ti/knav_qmss_acc.c:1
drivers/soc/ti/knav_qmss_queue.c:2
drivers/virtio/virtio_pci_common.c:2

Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Cc: netdev@vger.kernel.org
Link: http://lkml.kernel.org/r/20141219012206.4220.27491.stgit@jbrandeb-cp2.jf.intel.com
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>