linux-phytec-fsl

f2fs: remove redundant lines in allocate_data_block

There are redundant lines in allocate_data_block.

In this function, we call refresh_sit_entry with old seg and old curseg.
After that, we call locate_dirty_segment with old curseg.

But, the new address is always allocated from old curseg and
we call locate_dirty_segment with old curseg in refresh_sit_entry.
So, we do not need to call locate_dirty_segment with old curseg again.

We've discussed like below:

Jaegeuk said:
 "When considering SSR, we need to take care of the following scenario.
  - old segno : X
  - new address : Z
  - old curseg : Y
  This means, a new block is supposed to be written to Z from X.
  And Z is newly allocated in the same path from Y.

  In that case, we should trigger locate_dirty_segment for Y, since
  it was a current_segment and can be dirty owing to SSR.
  But that was not included in the dirty list."

Changman said:
 "We already choosed old curseg(Y) and then we allocate new address(Z) from old
  curseg(Y). After that we call refresh_sit_entry(old address, new address).
  In the funcation, we call locate_dirty_segment with old seg and old curseg.
  So calling locate_dirty_segment after refresh_sit_entry again is redundant."

Jaegeuk said:
 "Right. The new address is always allocated from old_curseg."

Reviewed-by: Chao Yu <chao2.yu@samsung.com>
Signed-off-by: Dongho Sim <dh.sim@samsung.com>
Signed-off-by: Jaegeuk Kim <jaegeuk@kernel.org>