Merge branch 'Amiga-xsurf100'
Michael Schmitz says:
====================
New network driver for Amiga X-Surf 100 (m68k)
[This is a resend of my v3 series which was based on the wrong version and
tree. Only substantial change is to Asix AX99796B PHY driver.]
This patch series adds support for the Individual Computers X-Surf 100
network card for m68k Amiga, a network adapter based on the AX88796 chip set.
The driver was originally written for kernel version 3.19 by Michael Karcher
(see CC:), and adapted to 4.16+ for submission to netdev by me. Questions
regarding motivation for some of the changes are probably best directed at
Michael Karcher.
The driver has been tested by Adrian <glaubitz@physik.fu-berlin.de> who will
send his Tested-by tag separately.
A few changes to the ax88796 driver were required:
- to read the MAC address, some setup of the ax99796 chip must be done,
- attach to the MII bus only on device open to allow module unloading,
- allow to supersede ax_block_input/ax_block_output by card-specific
optimized code,
- use an optional interrupt status callback to allow easier sharing of the
card interrupt,
- set IRQF_SHARED if platform IRQ resource is marked shareable
The Asix Electronix PHY used on the X-Surf 100 is buggy, and causes the
software reset to hang if the previous command sent to the PHY was also
a soft reset. This bug requires addition of a PHY driver for Asix PHYs
to provide a fixed .soft_reset function, included in this series.
Some additional cleanup:
- do not attempt to free IRQ in ax_remove (complements 82533ad9a1c),
- clear platform drvdata on probe fail and module remove.
Changes since v1:
Raised in review by Andrew Lunn:
- move MII code around to avoid need for forward declaration,
- combine patches 2 and 7 to add cleanup in error path
Changes since v2:
- corrected authorship attribution to Michael Karcher
Suggested by Geert Uytterhoeven:
- use ei_local->reset_8390() instead of duplicating ax_reset_8390(),
- use %pR to format struct resource pointers,
- assign pdev and xs100 pointers in declaration,
- don't split error messages,
- change Kconfig logic to only require XSURF100 set on Amiga
Suggested by Andrew Lunn:
- add COMPILE_TEST to ax88796 Kconfig options,
- use new Asix PHY driver for X-Surf 100
Suggested by Andrew Lunn/Finn Thain:
- declare struct sk_buff in ax88796.h,
- correct whitespace error in ax88796.h
Changes since v3:
- various checkpatch cleanup
Andrew Lunn:
- don't duplicate genphy_soft_reset in Asix PHY driver, just call
genphy_soft_reset after writing zero to control register
====================
Signed-off-by: David S. Miller <davem@davemloft.net>
