uboot-phytec

mtd: nand: omap: fix ecc-layout for HAM1 ecc-scheme

As per OMAP3530 TRM referenced below [1]

For large-page NAND, ROM code expects following ecc-layout for HAM1 ecc-scheme
 - OOB[1] (offset of 1 *byte* from start of OOB) for x8 NAND device
 - OOB[2] (offset of 1 *word* from start of OOB) for x16 NAND device

Thus ecc-layout expected by ROM code for HAM1 ecc-scheme is:
 *for x8 NAND Device*
 +--------+---------+---------+---------+---------+---------+---------+
 | xxxx   | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] | ...
 +--------+---------+---------+---------+---------+---------+---------+

 *for x16 NAND Device*
 +--------+--------+---------+---------+---------+---------+---------+---------+
 | xxxxx  | xxxxx  | ECC[A0] | ECC[A1] | ECC[A2] | ECC[B0] | ECC[B1] | ECC[B2] |
 +--------+--------+---------+---------+---------+---------+---------+---------+

This patch fixes ecc-layout *only* for HAM1, as required by ROM-code
For other ecc-schemes like (BCH8) ecc-layout is same for x8 or x16 devices.

[1] OMAP3530: http://www.ti.com/product/omap3530
    TRM: http://www.ti.com/litv/pdf/spruf98x
		Chapter-25: Initialization Sub-topic: Memory Booting
		Section: 25.4.7.4 NAND
		Figure 25-19. ECC Locations in NAND Spare Areas

Reported-by: Stefan Roese <sr@denx.de>
Signed-off-by: Pekon Gupta <pekon@ti.com>
Tested-by: Stefan Roese <sr@denx.de>